Pressing Esc left the desktop and started the shell, but nothing appeared in the
emulator window -- the session was only visible on the host terminal. Once the
VBE adapter is switched into graphics mode the VGA text buffer at 0xB8000 stops
being scanned out, so every printk after that point reached serial and the
dmesg ring but never the display.
Disabling the DISPI interface does not bring the text console back; QEMU keeps
presenting the last framebuffer surface. So rather than clawing the adapter back
to text mode, the console is now rendered into the framebuffer:
drivers/video/fbcon.c draws the console with the shared 8x8 font and carries a
VT100 subset -- SGR colours, cursor addressing, relative moves, erase-display,
erase-line and save/restore. It presents a fixed 80x25 grid, because that is
the geometry the userland assumes (nano pads its bars with %-80s, the shell
wraps at TTY_WIDTH), with the glyph cell scaled to fill the active resolution.
The TTY driver became the console dispatcher: tty_write, tty_clear and
tty_set_cursor route to fbcon while it owns the display. That last one is what
makes nano work -- it positions with tty_set_cursor() rather than escapes, so
its full-screen repaint was landing as an append-only stream.
Also in this change:
- `video=WIDTHxHEIGHT` on the kernel command line selects the display mode,
defaulting to 1280x720 so a 16:9 host panel is filled rather than pillarboxed
when QEMU goes fullscreen. Rejects modes the heap cannot back.
- `make run-fullscreen`, plus zoom-to-fit on the windowed target, so scaling
preserves the guest aspect ratio instead of stretching it.
- QEMU targets raise vgamem_mb, since a 1280x720 32-bit surface exceeds the
default VGA memory.
- bochs_vbe_disable()/fb_set_active() let the framebuffer be marked dormant so
drawing routines no-op after a mode teardown.
Co-Authored-By: Claude Opus 5 <[email protected]>
Claude-Session: https://claude.ai/code/session_01L5yKJT4Wo2cV3rfPrwY5MP
- Add 'clear' and 'cls' builtin handlers in LazyBox shell
- Output ANSI \033[2J\033[H sequence on tty_clear() to clear serial/UART terminals
- Support both ASCII 0x7F (DEL) and 0x08 (BS) for Backspace in shell and nano editor
- Connect 16550 serial input to keyboard_get_key() on x86_64 for headless terminals
- Add ANSI escape sequence decoding for arrow keys (Up/Down/Left/Right/Home/End/Del)
- Update Makefile 'make run' and 'make qemu' with -display none for smooth terminal execution
- Add 'make run-gui' target for optional graphical SDL/GTK window
